Lapis

Pencil drawing techniques

The short how-tos every drawing on this site leans on, each with a diagram: which pencil to use, where light and shadow go, how to build a tone, how to measure, and perspective.

Pencil grades: 2H, HB, 2B and 4B, and when to use each

H pencils are hard and leave a light, thin line; B pencils are soft and leave a dark one; HB is in the middle. Three are enough to start: a 2H for the first light lines, an HB for the outline, and a 2B or 4B for the shadows. Switch to the soft pencil last, because its marks are hard to erase.

Pencil grades · Holding the pencil · Light lines · Sharpening the pencil

Light and shadow: core shadow, cast shadow and reflected light

Light falls on every round form in the same order. The side facing the light stays as paper. Where the form turns away from the light is the core shadow, its darkest band. Just inside the far edge a little reflected light bounces back from the table. On the table lies the cast shadow, darkest right under the object.

The family of light · Building a cast shadow

How to make a value scale with a pencil

Draw five boxes in a row. Leave the first as white paper, fill the last as dark as you can, and fill the three between them in even steps. While you draw, give each area a number from 1 to 5 and compare it with the scale. Squint to see the big tones: the details blur away and a few flat shapes remain.

The value scale · Squinting

Hatching, cross-hatching and smooth tones

Hatching is a tone made of short parallel lines. Cross-hatching lays a second layer across the first. To make a tone darker, put the lines closer together or add another layer instead of pressing harder: pressing shines and dents the paper. On a round object, curve the strokes around the form.

Hatching and cross-hatching · Lines that wrap the form · Smooth tones in layers

How to measure proportions with a pencil

Hold your pencil at arm's length with one eye closed. Put its tip on one edge of the object and your thumb on the other: that length is your unit. Keeping your arm straight, count how many units the other side is. On paper, keep the same ratio. You carry a ratio to the paper, not a length.

Measuring with your pencil · Drawing the gaps · Big to small · Looking from afar

How to draw ellipses and clear glass

Every circle seen at an angle is an ellipse: the rim of a mug, the base of a glass. Draw a centre line first and sit the ellipse across it, the same on both sides. Draw the whole ellipse, the back half too, in a few light loops. The ends are round, never pointed.

Drawing ellipses · Drawing clear glass

One-point and two-point perspective

The horizon is your eye level. In one-point perspective, every line that runs into depth meets at one vanishing point on the horizon, and the side facing you is drawn flat. In two-point perspective the object faces you with a corner: its two sides run to two points on the same horizon, and upright edges stay upright.

Horizon and vanishing point · Two vanishing points · Spacing with a diagonal

Erasing, cleaning up and lifting highlights

Press a kneaded eraser onto the line and lift it; don't rub, because rubbing spreads the graphite and roughens the paper. Lighten the construction lines before you shade. For highlights, tone the whole area first, then knead the eraser to a point or a thin edge and press and lift where the light is.

Erasing and cleaning up · Lifting highlights

See them used in the drawings, step by step